UP-CONV-MODULE Up-Conversion Module

TECHNICAL DATA

Technical specifications

Specifications correspond to the product catalogue. Contact our technical team for configuration and operating conditions.

UP-CONV-MODULE Technical specifications
Parameter	Specification / typical value
IF In IF In
IF Input Frequency	XX0MHz
IF Input Bandwidth	4.5MHz
Input Power	-10dBm
IF In-Band Flatness	≤±0.3dB/4.5MHz BW
Input VSWR	≤1.3
IF Filter Off-Center Rejection at ±9MHz	≥40dBc
RF Out RF Out
Output Frequency Range	X02MHz～X52MHz
Output Frequency Step	1MHz
Output Power	7±0.5dBm
RF Flatness	≤±0.3dB/50MHz BW
Third-Order Intermodulation	≤-45dBc (two-tone, single-tone 1dBm out)
Spurious Suppression	≥85dBc
Harmonic Suppression	≥85dBc
Image Rejection	≥85dBc
Noise Figure	≤12dB
Group Delay Variation	≤25ns (4.5MHz BW)
Switching Time	≤5us
Output VSWR	≤1.3
LO LO
LO Frequency	X42MHz～X92 MHz
Hopping Step	1MHz
Coupled Output Power	0±2dBm
Hopping Time	≤70us
LO Phase Noise	≤-105dBc/Hz@100Hz; ≤-115dBc/Hz@1kHz; ≤-118dBc/Hz@10kHz; ≤-119dBc/Hz@100kHz

Specifications are subject to change without notice. Contact our technical team for full conditions, interface definitions, and ordering information.

Some frequencies retain the X placeholders used in the catalogue. Contact our team to confirm the specific frequency configuration.

Take anti-static precautions and ensure device ports are clean before use.
Use a torque wrench to tighten coupling nuts where applicable.
Check connector pin depth before calibration to avoid damage to calibration devices.

EXPLORE MORE