DOWN-CONV-MODULE Down-Conversion Module

TECHNICAL DATA

Technical specifications

Specifications correspond to the product catalogue. Contact our technical team for configuration and operating conditions.

DOWN-CONV-MODULE Technical specifications
Parameter	Specification / typical value
RF In RF In
RF Input Frequency Range	X02 MHz～X52 MHz
RF Center Frequency Step	1MHz
Max Input Power	-10dBm
RF Flatness	≤±0.3dB/50MHz BW
Input VSWR	≤1.3
IF Center Frequency	XX0MHz
IF Signal Bandwidth	4.5MHz
IF Out IF Out
Conversion Gain	20±0.5dB
IF In-Band Flatness	≤±0.3dB/4.5MHz BW
Third-Order Intermodulation	≤-45dBc (two-tone, single-tone 4dBm out)
Spurious Suppression	≥70dBc (input -10dBm)
Harmonic Suppression	≥70dBc (input -10dBm)
Image Rejection	≥70dBc
Noise Figure	≤8dB
IF Filter Off-Center Rejection at ±9MHz	≥40dBc
Group Delay Variation	≤25ns (4.5MHz BW)
Switching Time	≤5us
Output VSWR	≤1.3
LO LO
LO Frequency	X42MHz～X92MHz
Hopping Step	1MHz
Coupled Output Power	0±2dBm
Hopping Time	≤70us
LO Phase Noise	≤-105dBc/Hz@100Hz; ≤-115dBc/Hz@1kHz; ≤-118dBc/Hz@10kHz; ≤-119dBc/Hz@100kHz

Specifications are subject to change without notice. Contact our technical team for full conditions, interface definitions, and ordering information.

Some frequencies retain the X placeholders used in the catalogue. Contact our team to confirm the specific frequency configuration.

Take anti-static precautions and ensure device ports are clean before use.
Use a torque wrench to tighten coupling nuts where applicable.
Check connector pin depth before calibration to avoid damage to calibration devices.

EXPLORE MORE