SIG-SWITCH-MODULE Signal Switching Module

TECHNICAL DATA

Technical specifications

Specifications correspond to the product catalogue. Contact our technical team for configuration and operating conditions.

SIG-SWITCH-MODULE Technical specifications
Parameter	Specification / typical value
Input Input
IF Input Frequency	X.5GHz～X.5GHz
Power	≤+10dBm
Input Impedance	50Ω
IF1/IF2/Train Input Frequency	XX37.5MHz～XX62.5MHz
Power	≤+10dBm
Input Impedance	50Ω
Output Output
IF & Train Output -1dB Bandwidth	1040MHz
Out-of-Band Rejection	≤-45dBc@X.7GHz; ≤-45dBc@X20MHz
Loss	<7dB
Flatness	≤±1dB
Output Impedance	50Ω
IF Combining Out1/Out2 Frequency	XX37.5MHz～XX62.5MHz
Flatness	≤±0.5dB
Loss	≤4.5dB(X14~X17 & X16~X18), ≤9.5dB(X15~X17/X18)
Input Impedance	50Ω
100MHz Ref Divider 100MHz Ref Divider
No. of Ports	4
Loss	≤8dB
I/O Impedance	50Ω
Opto-Electrical Opto-Electrical
Connector	SMA
Input Level	+3.3V TTL; pulse freq: 100Hz~5kHz
Fiber Connector	ST 820nm, fiber 62.5um/125um
TX-RX Isolation	≥120dBc
Isolation	≥60dBc(XS14-XS18, XS16-XS17)
Supply Supply
+12V	Supported
Power Consumption	≤10W

Specifications are subject to change without notice. Contact our technical team for full conditions, interface definitions, and ordering information.

Some frequencies retain the X placeholders used in the catalogue. Contact our team to confirm the specific frequency configuration.

Take anti-static precautions and ensure device ports are clean before use.
Use a torque wrench to tighten coupling nuts where applicable.
Check connector pin depth before calibration to avoid damage to calibration devices.

EXPLORE MORE