IF-CONV-CARD IF Conversion Card

TECHNICAL DATA

Technical specifications

Specifications correspond to the product catalogue. Contact our technical team for configuration and operating conditions.

IF-CONV-CARD Technical specifications
Parameter	Specification / typical value
RF Input RF Input
Number of Channels	1
Frequency Range (Center)	XX0MHz～XXX0MHz
Input Level Range	-80dBm～0dBm
Burn-Out Resistance	+25dBm
Input Impedance	50Ω
Ref Clock Ref Clock
Frequency	100MHz
Level	-5～+5dBm
Mode	Sine Wave
Input Impedance	50Ω
IF Output IF Output
Number of Channels	6
Center Frequency	X00MHz
Frequency Step	1MHz
1dB Bandwidth	≥150MHz
Out-of-Band Rejection	≥50dBc@≤X75MHz; ≥50dBc@≥X25MHz
Output P1dB	≥10dBm
Attenuation Range	0～60dB
Step	1dB
Accuracy	<±1dB (fully calibrated)
Max Conversion Gain	≥60dB
In-Band Amplitude Flatness	≤±1.5dB (within 150MHz BW); ≤±2dB (full band)
Spurious Suppression	≥60dBc
Third-Order Intermodulation	≥60dBc (output -10dBm, two-tone 5MHz spacing)
Image Rejection	≥60dBc
Output Impedance	50Ω

Specifications are subject to change without notice. Contact our technical team for full conditions, interface definitions, and ordering information.

Some frequencies retain the X placeholders used in the catalogue. Contact our team to confirm the specific frequency configuration.

Take anti-static precautions and ensure device ports are clean before use.
Use a torque wrench to tighten coupling nuts where applicable.
Check connector pin depth before calibration to avoid damage to calibration devices.

EXPLORE MORE