MICROWAVE · INSTRUMENTS · BOARDS · MODULESgeorge@hportek.com

Microwave Modules

KA-FREQ-SYNTH-CARDKa-Band Frequency Synthesizer Card

This product synthesizes widely hopping and finely adjustable RF frequencies to provide LO signals for up/down converters, while simultaneously outputting clock signals. It consists of a synchronous crystal oscillator module, a frequency multiplier and filter module, a transceiver frequency source module, and a digital board. With a miniaturized design, it is integrated and packaged as a 3U VPX board.

TECHNICAL DATA

Technical specifications

Specifications correspond to the product catalogue. Contact our technical team for configuration and operating conditions.

KA-FREQ-SYNTH-CARD Technical specifications
ParameterSpecification / typical value
Frequency RangeKa-Band
Frequency Step≤100MHz
Output Power14~16dBm
Hopping Time≤100μs
Phase Noise≤-90dBc@1kHz
Spurious Suppression≥50dBc

Specifications are subject to change without notice. Contact our technical team for full conditions, interface definitions, and ordering information.

SYSTEM ARCHITECTURE

Product block diagrams

KA-FREQ-SYNTH-CARD block diagram 1
KA-FREQ-SYNTH-CARD / Diagram 1 Open full image ↗

Handling notes

  • Take anti-static precautions and ensure device ports are clean before use.
  • Use a torque wrench to tighten coupling nuts where applicable.
  • Check connector pin depth before calibration to avoid damage to calibration devices.

EXPLORE MORE

Related products

Explore category

LET’S CONNECT

Find the right product for your next breakthrough.

Talk to our team about your measurement, signal processing, and system integration requirements.

Contact our team