S-BAND-DOWN-CONV S-Band Down-Conversion Assembly

TECHNICAL DATA

Technical specifications

Specifications correspond to the product catalogue. Contact our technical team for configuration and operating conditions.

S-BAND-DOWN-CONV Technical specifications
Parameter	Specification / typical value
Input Frequency	XX00MHz～XX00MHz, dual channel
Input VSWR	≤1.5
Input Power	-105dBm～-15dBm
Max Damage-Resistant Power	10dBm
Output Center Frequency	70MHz, dual channel
IF Bandwidth (1dB)	≥40MHz
IF Bandwidth (3dB)	≥45MHz
Output VSWR	≤1.5
Output Frequency Step	≤100kHz
Output Power	-60dBm~0dBm
Output Spurious Suppression	≤-50dBc (output power P: -40dBm≤P≤0dBm)
Channel Isolation	≥60dB
Output P1dB	≥8dBm (measured at gain=15dB)
Third-Order Intermodulation	≤-38dBc (output -15dBm, gain 15dB)
Phase Noise	≤-72dBc/Hz@100Hz; ≤-88dBc/Hz@1kHz; ≤-92dBc/Hz@10kHz; ≤-100dBc/Hz@100kHz

Specifications are subject to change without notice. Contact our technical team for full conditions, interface definitions, and ordering information.

Some frequencies retain the X placeholders used in the catalogue. Contact our team to confirm the specific frequency configuration.

Take anti-static precautions and ensure device ports are clean before use.
Use a torque wrench to tighten coupling nuts where applicable.
Check connector pin depth before calibration to avoid damage to calibration devices.

EXPLORE MORE